STINGER II i measuring arm

STINGER II i series coordinate measuring arm manufactured in the USA by the CimCore company constitutes as a cost-efficient solution in the scope of production, measurements, and so-called reverse engineering. STINGER IIi is offered in measurement ranges from 2.4 m to 3.6 m. The measurement range is determined by the reach of arm expressed with a diameter of a ball.

Basic benefits of the CimCore Stinger II i series arms

• Heidenhain-bran encoders made especially for the CimCore Company with the so-called wide-track bearing
• mobility that enables measurements directly on a production floor
• unlimited axle turning, which extremely facilitates the operator’s work
• automated recognition of a tip and no need for its calibration after replacement
• arm tubes made from graphite and carbon fibre that provide high mechanical resistance and dimensional thermal stability
• counterweight that allows the operator to handle the machine with one hand
• QuickCheckTools software for simple geometrical measurements along with free updates for the whole period of service of the device
• IP64 protection degree that allows the arm to operate directly on a production floor in the oil mist and/or dustiness conditions
• ability to move the arm during a measurement, which increases the measurement range of the system
• ability to use optical probes to measure pipes and special DOCS software, which allows to use the arm also as a pipe control station 
• broad selection of mounting method (magnetic base, stands, ect.) 
• maintenance and calibration performed in Oberon3d headquarters in Tychy
• low weight of machinery, which significantly increases mobility
• possibility of mounting a laser matrix that enables the possibility to perform scans on a 6-axle arm
• battery power supply option
• broad range of allowed ambient conditions
• work temperature: 0°C – 46°C
• relative humidity 5% – 95% non-condensed

Basic paramters of CimCore Stinger IIi arms